2022-09-08
5
Sliding Door Automatic Control Device
19916437
Installation Instructions
Install the Motor
I M P O R T A N T
Check the door for proper operation before proceeding.
Make the sure the panels are square and operating
smoothly. Make sure you have proper head jamb clear-
ance above the panels for the belt to travel. Make sure
the locking hardware locks and engages properly.
H i n t
You will align the motor so it is centered on the lead pan-
el. Mark a centerline in the motor cavity to aid installa-
tion. The front of the motor is the side with one stand-off
at the top of the motor.
1.
Install a screw on their centerline within 3" of the stud
and leave the head proud about 3/4"-1".
Figure 8
2.
Hang the motor by the slotted hole on the front edge
of the mounting plate.
Figure 9
3.
Pre-drill with a 7/64" drill bit and fasten the four
corners with #8x 3" screws provided
