Marvin Sliding Door Automatic Control Device, Руководство по установке

Страница: 7 / 18

2022-09-08 7 Sliding Door Automatic Control Device
19916437 Installation Instructions
Install the Control Box
The control box can be located within 100’ of the motor.
Use an accessible, well lit location in an A/V closet or
utility room separate from the motor cavity. Mount the
control box chest high in a well lit space.
1. On the front of the control box, make sure the AC and
Battery switches are in the off position. See Figure 11 .
Figure 11
2. Mount the box from the side or back using the
installation keyholes on the control box and the
installation screws provided. Use an extended #2
Phillips bit to aid in installation. When mounting on the
back start with the bottom left screw first. Fasten all
screws to securely mount the control box (4 screws for
rear mount, 2 screws for side mount).
See Figure 12 .
Figure 12 Rear mounting holes. Controller removed for illustra-
tive purposes only.
3. Determine which knockouts to remove to allow
power and CAT5e cables to enter the control box.
I M P O R T A N T
Make sure you leave some slack in the cables before
connecting to the control box. Make sure there are no
tight bends in any cable.
Figure 13
1 Knockouts