Maruyama Mister MM300, Руководство владельца/оператора

Страница: 18 / 20

— 17 —
WARNING
POTENTIAL HAZARD
• When engine is running, fan is rotating
and other parts are moving.
WHAT CAN HAPPEN
• Contact with rotating fan or other
moving par ts could cause serious
personal injury or death.
HOW TO AVOID THE HAZARD
• Always turn off your Mister before you
clean or perform any maintenance on it.
WARNING
POTENTIAL HAZARD
• Muffler surface becomes hot when
Mister is in operation and remains hot
for some time after the engine is shut
off.
WHAT CAN HAPPEN
• Contact with hot muffler surfaces could
cause a burn.
HOW TO AVOID THE HAZARD
• Make sure the muffler is cool before
inspecting and cleaning the spark
arrester.
EXHAUST MUFFLER
Maintenance Interval
The muffler should be inspected and cleaned
after each 100 hours of use.
Muffler Maintenance
1. With the engine at ambient (room)
temperature, loosen the knob and remove the
air cleaner cover. (See cooling fin cleaning.)
2. Twist the high tension lead boot on spark plug
back and forth a couple of times to loosen the
boot, then pull the boot of the spark plug.
3. Remove the four screws, and remove the top
cover (see the cooling fin cleaning).
4. Remove the spark arrester (see spark
arrester maintenance). Clean the muffler
with a stiff brush.
IMPORTANT: Be careful not to allow any dirt
or debris to fall into the exhaust port, as
this can cause engine damage.
5. Reinstall the spark arrester and tail onto the
muffler, then reinstall and tighten the two
screws. The hole of tail must be located in
left. (See spark arrester maintenance)
6. Reinstall the top cover and the cleaner cover.
The MARUYAMA mister will provide maximum
performance for many hours, if it is maintained
properly. Good maintenance includes regular
checking of all fasteners for correct tightness,
and cleaning the entire machine. Contact an
authorized MARUYAMA dealer for additional
maintenance suggestions.
GENERAL CLEANING AND
TIGHTENING
SPARK ARRESTER
Maintenance Interval
• The spark arrester should be inspected and
cleaned after every 25 hours of use.
• Replace the screen if it cannot be thoroughly
cleaned, or if it is damaged.
Spark Arrester Maintenance
1. With the engine at ambient (room)
temperature, loosen the knob and remove
the air cleaner cover (see Cooling Fin
Cleaning).
2. Twist the high tension lead boot on the spark
plug back and forth a couple of times to
loosen the boot, then pull the boot off of the
spark plug.
3. Remove the four screws and remove the top
cover (see Cooling Fin Cleaning) .
4. Remove the two screws retaining the muffler.
5. Remove and clean the tail, gasket and spark
arrester with a safety solvent and a stiff
brush. If any part cannot be thoroughly
cleaned, it must be replaced.
6. Reinstall the spark arrester and tail onto the
muffler, then reinstall and tighten the two
screws.