Martin Exterior 400, Руководство пользователя

Страница: 12 / 44

12
Exterior 400 Image Projector user manual
4. With reference to Figure 3 on page 10, insert the new gobo in the holder with the side that must face
towards the LEDs facing upwards, towards the spring.
5. Insert the spring with the narrow end against the gobo, as shown in Figure 5. To identify the narrow end,
press the spring flat: the narrow end is on the inside. Push the end of the spring in under the lip of the
holder.
6. Check that the gobo is seated flush against the holder. Press the spring as flat as possible against the
back of the gobo.
7. Install the goboholder in the gobo wheel as described in the previous section.
Reinstallation after accessing the effects module
To reinstall the effects module and front cover:
1. Lower the effects module into position in the housing. Note the number of pins in the multi-connectors to
the module and reconnect them.
2. See Figure 1 on page 8. Using a T-bar or long Allen key, reinstall the four effects module retaining
screws
D
.
3. Check the front cover seal
C
. If it is not in perfect condition, it must be replaced with a new item from
Martin™ to maintain the fixture’s IP65 rating.
4. Place the front cover
B
with its seal
C
in position on the front of the fixture housing
F
and insert the eight
Allen screws
A
. Tighten the screws until they are finger-tight only.
5. Using a torque driver, cross-tighten the screws gradually – tightening all screws opposite each other,
working around the cover in at least three stages – to a torque of 8 Nm (5.9 ft.-lbs.). Do not over-tighten,
or the front glass may break.
6. You can now either apply power or proceed with physical installation.