Martin Exterior 400, Руководство пользователя

Страница: 9 / 44

Installing color filters and gobos
9
Installing color filters
To install a filter in the Exterior 400 Image Projector effects module:
1. See Figure 2. Refer to the diagram for filter position numbers. The color wheel is shown from the rear
(the side facing the back of the effects module, away from the front cover). It will help you identify filter
positions if you note the position of the small magnet
A
on the color wheel opposite the open slot.
2. If a filter has already been installed, push it away from the color wheel towards the gobo wheel slightly to
release it, then grasp it by the edges and remove it. If your fingers are too large, protect the glass with a
piece of paper that has been folded several times and grasp the filter with needle-nose pliers.
3. To install a filter, push the filter
B
in between the color wheel
C
and the gobo wheel
D
and slide it under
the retention spring in the color wheel until it snaps into place on the color wheel and the raised lug
E
in
the filterholder engages in its cutout
F
.
1
2
3
4 5
6
7
8
9
Figure 2: Installing a color filter
Color filter positions
(color wheel seen from rear,
side facing towards LEDs)
A
B
D
C
E
F