Setup
67
• The factory default values are zero for all Luminaires.
To program a Luminaire’s default scene with the remote control unit:
1. Set the Luminaire to
Remote Control
mode (see previous section).
2. Press the
–
key to enter
Scene Setting
mode. The Luminaire
responds with one short flash (blue in RGBW Luminaires) and the
LEDs switch to the last stored scene. LEDs flash each time the
Luminaire accepts an entry for the rest of this procedure.
3. In RGBW Luminaires, use digits
1
-
4
on the numeric keypad to select
the individual LEDs:
•
1
selects Red
•
2
selects Green
•
3
selects Blue
•
4
selects White
4. Set LED intensity as follows:
•
Increases the intensity of the selected LEDs (in RGBW
Luminaires) or all LEDs
•
Decreases the intensity of the selected LEDs (in RGBW
Luminaires) or all LEDs
•
Sets all luminaires to zero intensity
•
Sets all luminaires to full intensity
5. When you have programmed the scene, press
Sign
to store the
scene in the Luminaire and exit
Scene Setting
Mode.
An Exterior 50 & 100 Luminaire will display its default scene each time it is
powered on, unless it receives a DMX signal.
Setting up via RDM using Martin M-PC™
The Exterior 50 & 100 system is compatible with RDM (Remote Device
Management). Using an RDM-compliant DMX controller such as the
Martin M-PC™ Windows application, you can communicate with the
Luminaires on the data link via RDM. You can retrieve Luminaire data,
and you can also:
• Set the DMX addresses of all the Luminaires on the link
• Set Luminaires to raw or calibrated modes.
To use Martin M-PC, connect a PC running this application to the data link
using the Martin USB Duo™ USB/DMX interface box.
Содержание Exterior 100
Страница 1: ...Martin Exterior 50 IP68 Martin Exterior 100 IP68 System User Manual TM TM...
Страница 82: ......
Страница 83: ......
Страница 84: ...www martin com Olof Palmes All 18 8200 Aarhus N Denmark Tel 45 8740 0000 Fax 45 8740 0010...