Installing Luminaires
51
Fastening to DIN rail
Using the attachment options on their mounting brackets and the two
M3x10 Torx screws supplied with each Luminaire, Exterior 50 & 100
Luminaires can be mounted on standard 35 mm top-hat section DIN rail
that is fastened to a flat surface. See Figure 25.
To fasten an Exterior 50 or 100 mounting bracket to 35 mm DIN rail:
1. Check that the DIN rail is securely mounted on a flat surface that can
hold ten times the weight of all the hardware to be installed on it.
2. Hook the upper edge of the profile in the Luminaire mounting bracket
over the DIN rail and swing the mounting bracket down so that it
hangs flat against the DIN rail (you may need to loosen the two screws
in the mounting bracket base slightly for clearance).
3. Adjust for position, then tighten both screws in the mounting bracket
base securely behind the lower lip in the DIN rail.
4. Check that the Luminaire is held securely and cannot fall.
Figure 25: Fastening to DIN rail
35 25
1
7 - 15
Ø5
7.5
110 - 150
Ø5
35 25
1
7 - 15
7.5
75 - 100
Ø5
Exterior 100
Exterior 50
M3x10 screws (supplied)
4 mm screws (not supplied)
35 mm DIN rail (not supplied)
2.5
Содержание Exterior 100
Страница 1: ...Martin Exterior 50 IP68 Martin Exterior 100 IP68 System User Manual TM TM...
Страница 82: ......
Страница 83: ......
Страница 84: ...www martin com Olof Palmes All 18 8200 Aarhus N Denmark Tel 45 8740 0000 Fax 45 8740 0010...