Service manual
15 of 20
Atomic 3000 LED - Revision A, 11-30-2017
2.
Remove the four Torx25 screws (2) on each side
of the handle.
Figure 30: Removing the screws on the handle
Figure 31: Brackets and springs
3. Follow the procedure in reverse order.
NOTE! Reuse the brackets (3) and springs (4).
Calibrating the PSU
1. Make sure you have the calibration number. See
figure 17 on page 10.
2.
Power up the product and let it boot up for five
seconds.
NOTE! The DMX address will be displayed after a
successful boot up.
2
4
3
Figure 32: Successful boot up
2
