![background image](http://html1.mh-extra.com/html/martin-audio/m3-schematics/m3-schematics_user-manual_1732948002.webp)
1 INTRODUCTION
Thank you for purchasing a Martin Audio M3 system controller. The M3
controller is used to optimise the performance of the Blackline series of
loudspeakers in all modes of operation.
2
UNPACKING
Each Martin M3 controller is built and tested to the highest standard and
thoroughly inspected before it leaves the factory. After unpacking the unit,
please examine it carefully for any signs of transit damage and inform your
dealer if any such damage is found. It is suggested that you retain the
original packaging so that the unit can be repacked at a future date if
necessary.
Please note that Martin Audio and its distributors cannot accept
responsibility for damage to any returned product through the use of non-
approved packaging.
3 INSTALLATION
The M3 requires a vertical rack space of 1U (1.75"/44.5mm). As with any
low level signal processing equipment it is recommended that it is sited well
away from any high level sources of electromagnetic radiation, and should
not for example be placed directly above power amplifiers or lighting
dimmers, which could induce residual noise into the system.
Martin Audio – M3 System Controller
E
NGLISH
2
This equipment conforms to the requirements of the
EMC Directive 89/336/EEC, amended by 92/31/EEC
and 93/68/EEC and the requirements of the Low
Voltage Directive 73/23/EEC, amended by 93/68/EEC.
Standards Applied
EMC
Emission
EN55103-1:1996
Immunity
EN55103-2:1996
Electrical Safety
EN60065:1998
CONTENTS
<
>
GUIDES