Marshall Electronics V-R185-DLW, Руководство по эксплуатации

Страница: 10 / 18

10
MAIN MENU AND NAVIGATION
Access and navigate the main menu using the RotoMenu ™ knob:
Using the RotoMenu knob
•
Press the RotoMenu ™ knob to enter the main menu.
• Rotate the knob to scroll up or down in the main menu or each submenu.
• Press the RotoMenu ™ knob to enter a submenu or choose a setting.
• To return to main menu from submenu, select ‘Back’ and press the RotoMenu ™ .
The menu timeout can be set in the OSD Timeout section of the OSD Config submenu.
Marker Setup Submenu
Use the Marker Setup submenu to select various on-screen markers, adjust the Marker Background, or toggle the Center Marker
ON or OFF.
Main Menu
Marker Setup Submenu
27
■
Limits
Use the Limits option to differentiate data (indicated by a red highlight) on the Waveform display that goes above a Limit Max
(maximum) and goes below a Limit Min (minimum) set in the Wave/Vector submenu. The Limit maximum and minimum can
be set from 0000 to 1023. Note: Setting the Limits option to ON will override the Colorize Waveform option. All Waveform
display data within the limits will appear in white.
■
Limit Max
Use this to set the desired maximum for the Limit display of the waveform monitor. Any Waveform data that goes beyond
this Limit Max will be displayed in red.
■
Limit Min
Use this to set the desired minimum for the Limit display of the waveform monitor. Any Waveform data that goes below this
Limit Max will be displayed in red.
■
Vectorscope Targets
Use the Vectorscope Targets option to set your Vectorscope targets up for 75% or 100% color bar signals. You can also set
your Vectorscope Targets to the OFF position.
■
Overlay Position
Use the Overlay Position option to place the Waveform, Vectorscope and Audio Level display on the Top or Bottom of the
screen while in the DLW Overlay display mode. You can also set your Overlay display to OFF.
■
Overlay Transparency
Use the Overlay Transparency option to set the transparency of the Waveform, Vectorscope and Audio Level display while in
DLW Overlay mode. Choose a value from 000-100. A low value will cause the Waveform, Vectorscope and Audio Level data
to blend into the background, while a high value will make the data appear more visible against the video display in the
background.
Ancillary Submenu
Use the Ancillary submenu to determine which ancillary packet IDs should be counted in the Ancillary Status portion of the
DLW monitor display.