Marshall Amplification AUTOBROIL FR15BG, Руководство пользователя

Страница: 15 / 39

VI. ASSEMBLY & DISASSEMBLY INSTRUCTIONS
1. The burner screen (Figure 4) may be replaced by removing the six screws from both sides of the burner
housing. The assembly will then slip out. Remove all old gasketing and replace it as shown. Compress
the new assembly into the burner housing with hand pressure all around the outside of the burner
housing. Next, place the assembly on a flat strong surface, such as a cement floor, and push the burner
housing down so as to drive the screen frame into the housing. Insert new screws and snug the screws in
a staggered sequence. Do not over tighten screws. While pushing on the back of the burner housing with
one hand, drive the screws in until the head of the screw comes in contact with the burner housing. These
screws will keep the frame tight against the gasket.
NOTE: IT IS IMPORTANT THAT THE NEW GASKET BE HELD IN PLACE WHILE ATTACHING
NEW SCREEN ASSEMBLY. THIS IS EASILY ACCOMPLISHED BY RUBBING A SMALL
AMOUNT OF PETROLEUM JELLY ALONG THE INSIDE LIP OF THE BURNER
HOUSING.
2. The restraining device is a separate line and should be anchored no less than 6" away from the gas
connector and in a parallel position to the flexible line. The following instructions refer to Figure 7. By
using the adjusting clips (1) alter the length of the cable (2) so that the overall length (3) is 3" to 6" shorter
than the length of the flexible gas line including the fitting. Then attach staple (4) to an existing wall or
other structurally sound surface. Attach scissor hook (5) to staple and secure with cotter pin. Finally attach
spring hook (6) to gas appliance as shown in Figure 7. Make certain that the overall length of the
restraining line is shorter than the gas line so no strain is placed on the gas line or piping when moving
the unit.
3. When replacing the thermocouple which attaches to the temperature controller, make certain it is inserted
through side wall of machine into cooking chamber exactly one inch (1").
4. Follow the procedures shown in Figure 8 for removing and cleaning lower burner shields.
5. To properly set the clearance between the meat stripper and the conveyor chain, the machine must
be HOT. Loosen the bolts holding the brackets to the sides of the unit and adjust their position until
the top edge of the stripper is within 1/16" of the hot conveyor.
WARNING: THIS APPLIANCE IS NOT CAPABLE OF BEING SAFELY PLACED INTO OPERATION
DURING A POWER FAILURE AND NO ATTEMPT TO OPERATE IT SHOULD BE MADE.
VII. REPLACEMENT PARTS-FR15BG
When ordering parts, make sure to specify the machine model number, type of gas and serial number as shown
by the label attached to the right side cover.
PARTS DESCRIPTION FIGURE
101357 Bearing 2
,
10
101978 Burner Gasket
4
14