Marshall Amplification AUTOBROIL FR15BG, Руководство пользователя

Страница: 14 / 39

H) Check that axle adjusting screw is not too tight. SOLUTION: Loosen so chain is not excessively tight.
8. PROBLEM: HOLDING TEMPERATURE WILL NOT REACH (90°C) 195°F.
POSSIBLE CAUSE:
* A) Check that overhead ThermoGlo™ is hot. SOLUTION: Replace element after making sure element is
receiving power.
* B) Check element connections on bottom heating element.
* C) Using a surface thermometer on top of platen, check that temperature controller is allowing platens to heat to
the desired temperature.
* D) The temperature sensor attached to the bottom heated plate has failed. This condition
causes the controller to flash "EEE" or "999". SOLUTION: Check to be sure sensor leads are securely
fastened to temperature controller. If so, then replace sensor.
9. PROBLEM: HIGH/LOW CONTROL DOES NOT WORK.
POSSIBLE CAUSE:
A) Determine gas pressure by checking gas pressure gauge. SOLUTION: Adjust per instructions on Page
6.
B) If unit stays in high or low, check that control is properly set for about (399°C) 750°F. SOLUTION: Reset
to proper temperature as shown in Item 3 on Page 8.
C) If control flashes "EEE" or "999", then inspect thermocouple. SOLUTION: Check to be sure sensor leads are
securely fastened to temperature controller. If so, then replace sensor.
* INSTRUCTIONS MARKED WITH ASTERISKS SHOULD BE PERFORMED BY AUTHORIZED SERVICE
PERSONNEL.
10. PROBLEM: HAMBURGERS WILL NOT FALL CORRECTLY.
POSSIBLE CAUSE:
A) Check for build-up of black residue on teflon sheet caused by lack of and/or improper cleaning.
SOLUTION: Clean teflon sheet at least daily (See Item 7, Page 9).
B) Teflon sheet is worn or damaged. SOLUTION: SHEET MUST BE REPLACED.
C) Meat stripper is dirty or adjusted too far from conveyor (Figure 2). SOLUTION: Clean and reposition near
chain by moving brackets that hold stripper. See instruction 5 on page 14.
13