the slide switch to the middle [REMOTE] position and then push the small pushbutton to begin programming. Bring
the transmitter close to the receiver and then press the power button [R] on the transmitter. An audible beep will
sound to indicate the system is programmed and ready to be used.
Electrical Supply in Series: The entire IPI system can be powered by a
single power source (i.e. by the AC Adapter). This is advantageous if
you do not want to supply extra batteries. To achieve this simply con-
nect the AC Adapter into the Remote Control wiring harness instead of
the main IPI harness. From the Remote wiring harness, use its male
plug-in connector and connect it to the female plug-in in the main IPI
harness. Now the circuit is complete. So the way it works is that electri-
cal power is supplied to the Remote Receiver module and then pro-
ceeds to the Main IPI module. Furthermore, note that a Backup Battery
Pack is not required in this configuration. Instead, batteries in the
Remote Receiver act as the backup supply.
NOTE:
The Remote Receiver module can also be located outside
of the appliance to a maximum of 6ft away installed in a certified
deep wall switch electrical box (2-3/4” depth). For this configuration
an extension wiring harness (P/N: 1001-P904SI) is required.
44
