MARMON ANGELO PO BX101E, Техническое руководство

Страница: 118 / 121

Copyright by Servizio Clienti ANGELO PO Spa
118
OPE
Oven door opening
or closure request.
Open or close
the oven door.
Inform the after-
sales service if
this message
continues to be
displayed.
The cooking
cycle does not
start until the
door has been
opened or
closed as
required.
Check the door magnetic micro
switch, to be correctly connected
to the power PCB by wires 42 and
43. It could be interruption or short
circuit.
CLE
Informs that
cleaning is required
Perform
cleaning
The oven
functions are
enabled and
therefore it is
possible to carry
out cooking
cycles
See paragraph “CLE and dEC
Warning”
dEC
Informs that
descaling is
required
Perform
descaling
The oven
functions are
enabled and
therefore it is
possible to carry
out cooking
cycles
See paragraph “CLE and dEC
Warning”
E01
Chamber probe
fault or not properly
connected.
CCC : Short circuit
--- : Open circuit
Alert the after-
sales service
The oven
functions are
disabled and
therefore
cooking cycles
cannot be
performed.
Check the cooking chamber
probe. It must have a resistance of
about 1100 Ohm at 25°C. It is
connected to poles 44 and 45 of
the power board.
E02
Core probe fault
CCC : Short circuit
--- : Open circuit
Check the
position of the
core probe or
alert the
assistance
service in case
of failure.
It is not possible
to carry out
cooking cycles
with a core
probe.
Check the core temperature
probe. It must have a resistance of
about 1100 Ohm at 25°C. It is
connected to poles 46 and 47 of
the power board.