INDUSTRIAL PRINTER QUICK START GUIDE
14
8.
Move the part to the center of the printable area displayed on the screen.
9.
Select your printer from the drop-down menu in the
Build Settings
panel at the right side of the screen.
10.
Click the
button in the bottom right corner of the page.
11.
Verify the print details and address any material warnings listed in the pop-up window.
12.
Select
Print Now
.
13.
Wait for the print to finish successfully; this should take less than an hour.
14.
Remove the print bed from the printer, and use the provided scraper to remove the part from the print
bed.
Warning: The scraper provided with Markforged printers is sharp and can cause injury if used
incorrectly.
Tip: Always scrape away from your body. When removing a part, brace the bed in a vertical position
against a sturdy level surface. Slide the scraper under the corner of the part. Always keep fingers or
other body parts out of the path of the scraper when removing a part from the print bed. Maintain an
acute angle between the scraper and the print bed while you are removing your part.
15.
Use warm water to clean the glue off the print bed.
Note: Do not use soaps or other cleaners, as these may damage or leave residue on the bed.
