INDUSTRIAL PRINTER QUICK START GUIDE
8
much moisture from the air will often cause underextrusion, which can in turn cause print failures. Please take
special care to
never
leave plastic materials exposed to ambient air, and
always
keep plastic materials in the
provided drybox.
Note: The term “load tube” is used in some older documentation, and is synonymous with “feed tube,”
here.
1.
Open the drybox inside your printer’s cabinet and remove the spindle from the inside. Pull the magnetic
spindle cap and spindle body apart.
2.
Remove the blue-tinted plastic feed tube from the accessory kit. Insert one end of the tube through the
opening in the back of the
cabinet
and into the adapter in the back of the drybox. Feed the other end of
the tube through the opening in the back of your
printer
, between the stepper motor and printer casing,
and through the clip attached to the printer casing (indicated below).
3.
After verifying that the plastic filament material bag has no holes, remove the spool from its packaging.
Place the two desiccant packs in the corners of the drybox.
4.
Place the plastic filament spool on the spindle and attach the spindle cap such that the magnets connect.
