Market Forge Industries STEAM-TECH PLUS STP-6E, Руководство пользователя

Страница: 5 / 35

2.2
2. INSTALLATION
FIGURE 2.2
DOmESTIC & ExpORT HEATER WIRING & RATINGS
2.3 REVERSING THE DOORS
The Steam-Tech Plus Pressureless Steam Cooker has cooking
compartment doors which are reversible, for your convenience.
For door assembly illustration and table, refer to page 6.12.
NOTE:
This procedure is identical for both the upper and lower
cooking compartments doors.
Remove the left large side panel by removing the screw
from the center of the bottom edge of the panel. Gripping
one of the louvers, slide the panel upwards until the bottom
edge of the panel is free to swing out slightly away from the
unit. Slide the panel down until its top edge is clear of the
top cap of the unit.
Open cooking compartment door.
Remove the two 5/16” bolts that attach the top hinge to the
front of the unit.
Slide the door upwards off the bottom hinge.
Remove the two 5/16” bolts that attach the bottom hinge to
1.
2.
3.
4.
5.
the front of the unit. NOTE: The top hinge is slightly larger
than the bottom hinge.
Remove the 4 black plastic hole plugs from the front unit.
Push the black hole plugs into the now vacant left upper
and lower hinge mounting holes.
Reinstall the top (
larger
) hinge and bolts into the right lower
hinge mounting holes. Rotate the hinge 180
O
for installa -
tion, so that the pin which the door rides on is now facing
up.
Remove the door latch assembly from the face of the unit.
The two door latch mounting nuts are located behind the
face of the unit and must be accessed by removing the
large side panels.
Remove the two white hole plugs from the left door latch
mounting holes and insert them into the right door latch
mounting holes (
where the door latch assembly was origi-
nally mounted
).
Rotate the door latch assembly 180
O
and install into the
6.
7.
8.
9.
10.