MA400
5
Hardware Kit Contents
Tuner/Amplifier Mounting
1.
Choose a mounting area for the tuner/amplifier module that will provide plenty of
ventilation to prevent the amplifier from overheating. The tuner/amplifier module can be
mounted in the horizontal or vertical position. Please note that when mounting in vertical
position, do not mount with the harness exit points facing straight up, as water can collect
around the chassis in these areas.
2.
Using the shortest length of the recommended size screws possible, mount the
tuner/amplifier as detailed in the diagram on the right.
3.
Route the tuner/amplifier harness and cable throughout the vessel as required. Keep
some slack in the harness/cables so it won't be too tight, as this can cause damage to the
wires.
4.
Follow the wiring diagram carefully and make certain all connections are secure and
insulated with crimp connectors or electrical tape to ensure proper operation.
5.
After completing the wiring connections, reconnect the negative terminal of the battery
and turn the unit on to confirm operation (vessel accessory switch must be on). If the unit
does not operate, disconnect battery, recheck all wiring and refer to the trouble-shooting
guide located in the back of the manual.
Reconnect Battery
When wiring is completed, reconnect the battery negative terminal.
1
3/4” HOLE REQUIRED FOR CABLE/CONNECTOR
STAINLESS STEEL #8 SCREWS REQUIRED
WITH MINIMUM LENGTH OF 1”
1/8” PILOT HOLES FOR SUPPLIED SELF-STARTING SCREWS
.180 PILOT HOLES WHEN USING THREADED MACHINE SCREWS
TUNER AMPLIFIER
MODULE
WIRED
COMMANDER
WIRED
COMMANDER
COVER
POWER HARNESS
10 FOOT WIRED COMMANDER EXTENSION CABLE
STAINLESS
STEEL TAPPING
SCREW (x4)