MA400
13
to stop scanning when the desired station is reached.
Preset Tuning
In Preset Tuning Mode, you can use the
►►
OR
◄◄
buttons (13, 15) to access all 18 preset
stations in sequential order.
Alternate Display Mode
Press the
DISP/SCROLL
button (12) to change the display information between single and dual
line text display. In dual line mode, both artist and title are available for viewing.
Press and hold
the
DISP/SCROLL
button to scroll the Artist/Song Title information.
While in category tuning list mode, press the
DISP/SCROLL
button in sequence to change the
display information from Channel Name, Artist, and Song Title.
Satellite Signal Strength
The display will indicate satellite reception strength as shown below.
Signal Strength
Strength Display
No Signal
Weak
Good
Excellent
Channel Lock
Access Channel Lock through the System Menu under the “SiriusXM Satellite Radio” menu. See
“System Menu” on page 8. Select “Set Lock Code”.
1.
Enter the default lock code of “0000”. To set the lock code:
a.
Press the
▲
/
▼
buttons (17, 16) to enter the first digit of the default code.
b.
Press the
INFO/ENTER
button (14) to move to the next digit.
c.
Repeat above steps to enter all 4 digits of the default code.
d.
Press the
▲
/
▼
buttons to enter the first digit of the new code.
e.
Press the
INFO/ENTER
button to move to the next digit.
f.
Repeat above steps to enter all 4 digits.
g.
Repeat above steps to confirm the new code.
2.
After setting a new four digit code, you can lock channels by entering the “Locked
Channels” menu.
3.
Upon entering the code, you can navigate the list using the
VOL +/-
buttons to highlight
the channels.
4.
Press the
INFO/ENTER
button (14) to Lock indicated by a ( ), or Unlock ( ) the
selected channel.
Reset SiriusXM Channel Lock Code
If you forget your Parental Control lock code, use the following directions to reset the code to the
default “0000”. Resetting the lock code will not affect the locked channels list.
1.
In SiriusXM mode, tune to Channel 0
2.
Set volume level to 0.
3.
Press
Power
button (11) to power off the unit.
4.
With power off, press and hold the
Power
button until the system version info is displayed
on the screen
5.
Press and hold the
Info/Enter
button (14) until display turns off.
6.
The lock code has no
w been reset to “0000”
