- 6 -
When viewing photos, pressing the MENU/ENTER button will display a
menu with two options: Delete and Exit. Use the Up and Down arrows to
cycle through these two options and the MENU/ENTER button to select. If
selecting the Delete option, another sub-menu will appear. To permanently
delete the selected media, select YES.
To load your media on your computer or other device you will need to use an
SD/Micro SD card reader to transfer the files. If you are experiencing
problems viewing your videos once loaded on your device, that specific
viewer may not be compatible with the Pursuit HD recorded media files.
Recommended media players include: Quicktime, KMPlayer, Mplayer,
GOMPlayer, and VLC. These media players should be downloadable on
your device. Please use one of these players to view all recorded videos
from your Pursuit HD. Windows Media Player will not support the Pursuit HD
media files.
USING YOUR CAMERA
Once you have a working knowledge of the system you can successfully
deploy the Camera in the water.
NOTE:
Make sure to remove the protective plastic film that covers the lens
for packaging.
Atop the Pursuit HD camera is a positioning system (three tabs). Set the
cable to the correct position to select your viewing angle (see “Camera
Positions”).
The depth of field (distance the camera can see underwater) depends on the
clarity of the water and the available light at the depth the camera is used. In
clear water, the depth can be many feet but in cloudy or murky water the
depth of field can be reduced to only a few inches due to particles suspended
in the water. Dirty or murky water and/or low light penetration can detract
from the quality of the color picture. Optimum color quality will result from
clear water and adequate light penetration.
NOTE:
The Color kill feature will turn on automatically when the camera’s
light sensor doesn’t detect enough light for optimal color viewing. This can
happen in low light conditions, in deep water, or when the ice is very thick
and/or covered with snow.
Calibration
Calibrating the camera will provide accurate camera direction readings. To
calibrate, first enter the SETTING menu, press MENU/ENTER and enter the
SYSTEM SETTING sub-menu. Using the Up/Down arrows cycle to
CALIBRATE and press MENU/ENTER. An on-screen instructional message
will appear on the screen: “Press the up arrow and rotate the camera
clockwise two full revolutions. Once complete press the down arrow to save”
Once you press the Up-arrow button to start the calibration the screen will
display “calibrating”. After two full revolutions have been achieved press the
down arrow and the screen will display “calibrated” and the process is
complete.
www.MarCumtech.com
