6
Personal safety:
•
Stay alert, watch what you are doing and use common sense when operating
a power tool. Do not use a power tool while you are tired or under the
influence of drugs, alcohol or medication.
•
Do not use the tool while standing on a ladder.
•
During use, the user and other persons standing in the vicinity must be
wearing appropriate P.P.E. including suitable goggles, safety helmet, ear
protectors, dust mask, protective gloves and safety boots.
•
Do not drill into any asbestos-containing materials.
•
Any modification of the tool is prohibited.
•
Unplug the power cord and make sure that the switch is in the off position if
the tool is left unattended e.g. during preparation and take-down works, in
case of power failure or while insertion or mounting of accessories.
•
Unplug the tool immediately if it stops for any reason. So, to avoid any
sudden start-up in an unattended condition.
•
Do not use the device if a part of the housing is defective or if there is
damage to the switch, supply line or plug.
•
When working, always move the mains, extension cable and suction hose to
the rear of the device.
•
The tool must be operated by two hands only using side handle provided or
on the correct drill stand.
•
Keep the handles dry, clean, and free from oil and grease.
•
Do not touch any rotating parts.
•
During manual operation, always hold the tool with both hands and stand
securely. Observe the tool reaction torque in case of blockage.
•
Always work in the correct manner, paying attention at all times. Do not use
the tool if you are tired or lacking in concentration.
•
For manual drilling, the DDM150 may only be used in conjunction with its
additional handle which comes with the tool.
Service
•
All damages to be repaired by a specialist only.
•
Power tools must be visually inspected by a specialist at regular intervals.
For further safety instructions, see the enclosed attachment!
Electrical Connection
Prior to putting the tool into operation, check the mains voltage for conformity with
the requirements as stated on the machines rating plate.
Voltage deviations of + 5 % and
– 15 % are permissible. The tool has a start-up
speed limiter to prevent automatic circuit breakers from being triggered
automatically.
Содержание DDM150
Страница 1: ...1 ...
