Marani LPP-360A, Руководство пользователя

Страница: 27 / 40

By pressing ENTER in this page, an arrow will appear on the left of the screen “
-> ”, then enter
into the setting interface 1 of RMS Comp:
By using “PM2” or “PM3” encoder, it is possible to set the RMS Comp as “ON” or “OFF”.
By rotating “PM1” encoder, will enter into the setting interface 2 of RMS Comp.
By using “PM2” and “PM3” encoder, user can set limiter attack threshold, with its range from -
10dBu to +20dBu.
By rotating “PM1” encoder again, it will enter setting interface 3 of RMS Comp.:
User can set RMS Cmp’s ratio by using “PM2” encoder from 2:1~32:1. With “PM3” encoder, it is
possible to set RMS Cmp’s knee from 0% ~ 100%.
By rotating “PM1” encoder, will enter into the setting interface 4 of RMS Comp.:
User can set RMS Cmp’s release time from 1ms to 10 sec by using “PM2” encoder, and set its
attack time by using “PM3” from 0.1ms to 5ms.
By rotating “PM1” encoder, will enter into the setting interface 5 of RMS Comp.:
By using “PM2” and “PM3” encoders, user can set the RMS Cmp’s make up from -12dBu to
+12dBu.
Limiter page – from this page it is possible to set the Output Channels Limiter. Limiter can be set
as “ON” or “OFF”. The following is an example screen for the Limiter page where it is ON:
Out-1 Out 1 RMS Cmp
->Bypass = On
Out-1 Out 1 RMS Cmp
->Threshold = +20.0dBu
Out-1 Out 1 RMS Cmp
->Ratio =32:1 Knee =0%
Out-1 Out 1 RMS Cmp
->Rel =1ms Atk =0.1ms
Out-1 Out 1 RMS Cmp
->Make-up = 0.0dB
Out-1 Out 1 Limiter
Bypass = On