Marani CLP-2600, Руководство пользователя

Страница: 32 / 38

CrossOver 1 page when the CLP2600 is set in Mono Mode
,
1 band
,
this page is not available
and the RMS single compressor will act on the overall input band
.
When the CLP2600 is set as 2 band compressor
,
then from this page it is possible to set the
Cross Over frequency separating the 2 bands dividing the full one
.
On each of the 2 bands
,
below and above the selected frequency
,
2 independent RMS
compressors will act
.
When the CLP2600 is set as 3 band compressor
,
then from this page it is possible to set the
Cross Over frequency separating the 2 lower bands of the 3 dividing the full one
.
On each of the 3 bands
,
3 independent RMS compressors will act
.
To set the band 1
(
Low
)
and the band 2
(
High
)
Cross Over Frequency press ENTER an arrow
will appear on the left of the screen
-> .
then use the PM2 encoder to set the desired number
of bands
.
th
The range of the selectable frequencies is going from 20Hz up to 20kHz by steps of 1
/
12 of
octave
.
Has to be taken carefully in account by the user that when selected the 3 band mode
,
the
CrossOver 1 selected frequency is not overlapping the one selected on the CrossOver 2 editing
page
.
The following is an example screen for the CrossOver 1 page where the Cross Over frequency is
set to 250Hz
:
CrossOver 2 page when the CLP2600 is set in Mono Mode
,
1 band
,
or in 2 band Mode
,
this
page is not available and the RMS single compressor
(
1 band mode selection
)
or the 2 RMS
compressors
(
2 band mode selection
)
will act on the overall or on the 2 selected input bands
.
When the CLP2600 is set as 3 band compressor
,
then from this page it is possible to set the
Cross Over frequency separating the 2 higher bands of the 3 dividing the full one
.
On each of the 3 bands
,
3 independent RMS compressors will act
.
To set the band 2
(
Mid
)
and the band 3
(
High
)
Cross Over Frequency press ENTER an arrow
will appear on the left of the screen
-> .
then use the PM2 encoder to set the desired number
of bands
.
th
The range of the selectable frequencies is going from 20Hz up to 20kHz by steps of 1
/
12 of
octave
.
Has to be taken carefully in account by the user that when selected the 3 band mode
,
the
CrossOver 2 selected frequency is not overlapping the one selected on the CrossOver 1 editing
page
.
The following is an example screen for the CrossOver 2 page where the Cross Over frequency is
set to 2500Hz
:
OutputA Left CrossOver 1
->
250 Hz
OutputA Left CrossOver 2
->
2500 Hz
30