Kurzanleitung / Short manual
Dehnspannfutter HydroChuck / Hydraulic chuck HydroChuck
31
Caution
Tool length adjustment with the tool clamped.
Performing an axial or radial tool length adjustment while the tool is
clamped will result in damage to the hydraulic chuck.
Do not perform a tool length adjustment while the tool is clamped.
NOTE
Use only a hex wrench with T-key
and
size 2.0
to tighten the tool length
setting screw (order no. 10006942).
3. Adjust the hydraulic chuck to the tool
length by turning the radial tool length
setting screw with the aid of the hex-
wrench with T-key (see "Figure 10:
Adjusting tool").
Figure 10: Adjusting tool
Warning
Inadequate clamping to the stop and non-compliance with the
minimum revolutions
may cause the tool to be released at high projectile speeds, which can
cause serious injuries.
During clamping, always screw in the clamping screw to the stop in
compliance with the minimum revolutions (see section "3.2
Technical data").
Caution
Using a power screwdriver to clamp the clamping screw
will increase the wear on the clamping screw.
The clamping screw must only be clamped manually.
NOTE
Ensure the minimum number of turns
from the clamping point to the stop
as stated in "Table 1: Minimum
number of turns, minimum clamping
depth and permissible transferable
torque" (page 31) is reached. If this
is not the case, for quality reasons
stop using the hydraulic chuck and
send it to MAPAL for repair.
Figure 11: Clamping tool
Содержание HydroChuck
Страница 35: ......
