Kurzanleitung / Short manual
Dehnspannfutter HydroChuck / Hydraulic chuck HydroChuck
21
Caution
Minimum clamping depth in the hydraulic chuck is not observed.
If the minimum clamping depth is not respected, the permissible
transferable torque will be reduced and the hydraulic chuck may
break.
Comply with the values for minimum clamping depth as per
"Table 1: Minimum number of turns, minimum clamping depth and
permissible transferable torque".
Caution
Tool length adjustment with the tool clamped.
Performing an axial or radial tool length adjustment while the tool is
completely clamped will result in damage to the hydraulic chuck.
Do not perform a tool length adjustment while the tool is clamped.
Caution
The use of shanks with form B and E (DIN 1835) or shanks with
form HB and HE (DIN 6535)
may result in inaccurate radial run-out and inaccurate balancing
quality of the entire system.
Only use shank forms A or perform a fine balancing of the entire
system.
Caution
If the bleeder screw with the red sealing is damaged,
stop using the hydraulic chuck.
Do not open the bleeder screw with the red sealing. Do not damage
the bleeder screw.
If the bleeder screw is damaged, send the hydraulic chuck to
MAPAL to be repaired.
Caution
Inadequate clamping to the stop
can affect the quality of the balancing and as a consequence cause
poor machining results. By insufficient clamping pressure, the
transmissible tightening torque may not be fully assembled.
During clamping, always screw in the clamping screw to the stop.
Caution
Using a power screwdriver to clamp the clamping screw
will increase the wear on the clamping screw.
The clamping screw must only be clamped manually.
Caution
The radial or axial tool length setting screw is tightened with the
wrong screwdriver.
Tightening the tool length setting screw with the wrong screwdriver will
result in damage to the tool length setting screw.
Use only a hex wrench with T-key to tighten the tool length setting
screw.
Содержание HydroChuck
Страница 35: ......
