Mapal HydroChuck, Краткое руководство

Страница: 20 / 36

20
Kurzanleitung / Short manual
Dehnspannfutter HydroChuck / Hydraulic chuck HydroChuck
Warning
Clamping and unclamping with the machine not stationary.
Clamping and unclamping the hydraulic chuck with the machine
running may result in serious injuries to the fingers and hands.

Switch off the machine. Only clamp and unclamp the hydraulic
chuck with the machine stationary or with it outside the machine.
Warning
Inadequate clamping to the stop and non-compliance with the
minimum revolutions
may cause the tool to be released at high projectile speeds, which can
cause serious injuries.

During clamping, always screw in the clamping screw to the stop in
compliance with the minimum revolutions (see section "3.2
Technical data").
Warning
By using long, cantilevered and heavy tools or extensions,
may cause the tool to be released at high projectile speeds, which can
cause serious injuries.

For long, cantilevered and heavy tools or extensions decrease the
speed according to user definition.

For special versions, note the speed of the drawing.
Warning
The spindle speed limits of the machine-side connection of the
hydraulic chuck are not observed.
Exceeding the spindle speed limits of the machine-side connection
can cause serious injuries to the operator.

Observe the spindle speed limits (see "Table 2: Estimated spindle
speed limits for hydraulic chuck with HSK connection" on page 25)
for HSK connections. The user is individually responsible for
determining spindle speed limits for the hydraulic chuck with other
machine-side connections.
Warning
Unclamping at high temperatures
may cause the tool to be released at high projectile speeds, which can
cause serious injuries.

Clamp and unclamp the clamping chuck only at room temperature.
Caution
Sharp cutting edges on the tool
can cause cutting injuries.

Wear protective gloves during tool changes.