19_J05xxx_ SPB 358 E&C.indd 2
9/1/19 5:10 PM
guidelines and instructions below.
Important Information
by the manufacturer or authorized service center in order to avoid hazards.
Do not disassemble, repair or alter the device without authorization.
Unauthorized disassembly or repair may cause failure and danger.
Unauthorized alteration may result in fire or breakdown.
Unless under supervision by persons responsible for their safety,
persons who are not familiar with the operating instructions, are not
allowed to operate the device.
If the rated voltage of the product is different from the local standard voltage, do not connect the device to the power source.
Otherwise, it may cause damage to the product or fire.
The installation place of the device should be stable enough to bear its weight
with considering the influence of strong wind, typhoon
and earthquake to avoid its falling and the damage it may cause.
Parts and components intended for the installation should be used.
Do not use parts and components other than those provided in
the packaging or recommended.
The filter should be used to reduce the occurrence of failures and prolong the service life of duct device, and the
filter should be
changed after hundreds of hours working.
Do not block the air inlets and outlets of the device as it may cause damage to the device.
Do not connect the device to power source until all installation work are finished.
The max operating temperature of the product is 40°C and shouldn’t be lower than 0°C.
Do not use the SPB 358 in dusty environments.
Otherwise the sensitivity, accuracy and lifetime of the device will be affected seriously.
The sensors and chips used in this device are high tech precision instruments; to minimize interference to the precision components,
please prevent the unit from being exposed to high temperature, high humidity, combustible gases and liquids.
RF Power (Output power): 1
6
dBm (2412MHz
–
2462MHz)
Declaration of Conformity
This device complies with the essential requirements in Directive 2014/53/EU, and can be used across EU member states or regions.
This device complies with part 15 of the FCC Rules (FCC ID: 2AQ3Q-SPB358). Operation is subject to the following two conditions:
(1)
This device may not cause harmful interference, and
(2)
This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s
authority to operate
the equipment.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses ,and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/ TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the radiator & your body.
2
