Manitowoc Grove TMS800E13, Руководство оператора

Страница: 130 / 168

SET-UP AND INSTALLATION TMS800E13 OPERATOR MANUAL
20
Published 02-06-2014, Control # 495-00
10.1 m (33 ft) Jib
1. Lower boom and secure tag line (1, Figure 4-41) to tip of
jib. Figure 4-41 shows the 7 m (23 ft) and 10.1 m (33 ft)
extension together.
2. Disconnect RCL Cable.
a. Remove connector (1, Figure 4-42) from junction
box on boom nose.
b. Install dummy plug (1, Figure 4-43) on junction box.
c. Route cable through jib and stow connector (1,
Figure 4-44).
3. Remove two pins attaching the jib to the left side of
boom nose (2, Figure 4-45). Stow the pins in the jib pin
holders (1) and install the retainer clips.
4. Completely retract boom.
5. Extend boom approximately 60.9 cm (2 feet).
6. Raise boom above horizontal.
NOTE: Step 7 is stowing with the 7 m (23 ft) section and
10.1 m (33 ft) section together. If the 7 m (23 ft)
section remained on the boom, proceed to step 9.
7. Use the tag line to maintain control of the jib, and swing
the extension into the stowed position Figure 4-46.
6642-30
FIGURE 4-41
1
6642-21
FIGURE 4-42
1
6642-20
FIGURE 4-43
1
6642-19
FIGURE 4-44
1
6642-31
FIGURE 4-45
1
2
Reference Only