5-3
3.
Remove the filter pan and position a METAL container with a sealable cover with a capacity
of EIGHT gallons (30 liters) or larger under the fryer drainpipe to drain the boil out solution.
The METAL container must be able to withstand the heat of the hot liquids.
4.
Drain out the solution using the drain to pan instructions in the FilterQuick
™
controller
manual and clean the frypot(s) thoroughly.
WARNING
Never leave the fryer unattended during this process. If the solution overflows,
press the ON/OFF switch to the OFF position immediately.
WARNING
NEVER drain boil out or cleaning solution into a shortening disposal unit (SDU), a
built-in filtration unit, a portable filter unit, or an OQS (Oil Quality Sensor). These
units are not intended for this purpose, and will be damaged by the solution and void
the warranty.
DANGER
When draining cleaning solution into an appropriate METAL container, make sure
the container will hold at least EIGHT gallons (30 liters) or more, otherwise hot/cold
liquid could overflow and cause injury.
5.
Refill the frypot(s) with clean water. Rinse the frypot(s) twice, drain and dry with a clean
towel. Thoroughly remove all water from the frypot and elements before refilling the frypot
with oil to the bottom OIL-LEVEL line.
6.
Ensure the FilterQuick controller is reset to proper set temperature for cooking or the fryer
will remain at 195°F(91°C) temperature.
DANGER
Ensure that the frypot is completely free of water before filling with oil. When the oil
is heated to cooking temperature, water in the frypot will cause splattering.
5.3.3 Cleaning the Oil Saddle Reservoir
During normal usage of your fryer, a deposit of carbonized oil will gradually form on the inside of
the oil saddle reservoir. It is recommended that the oil saddle be cleaned out according to the store’s
standard operating procedures. In lieu of standard operating procedures the oil saddle should be
cleaned at the completion of a frypot boil out or cold soak when oxidized oil has started to adhere to
and accumulate on the inner sides of the saddle. Clean outside the oil saddle reservoir with a clean,
damp cloth soaked with detergent. Wipe with a clean, damp cloth
.
Follow the procedure below to clean the inside of the oil saddle reservoir.
1.
Disconnect the quick disconnect on the bottom of the oil saddle reservoir.
2.
Pour the saddle oil into the clean empty frypot.
3.
Take the saddle to the sink.
4.
Fill with wash temperature water and add a dish detergent cleaning agent. Use the provided
nylon brush to scrub the residue from the sides and bottom of the saddle.
5.
Flush with water until all detergent residue is removed.
6.
Dry thoroughly before remounting to the frypot.
7.
Reconnect the quick disconnect.
8.
Fill with oil.