3–4
3.3.1.2 Adding Oil to the Oil Saddle Reservoir (Saddle Oil Reservoir only)
Remove the Oil Saddle Reservoir lid (see Figure 3) and fill with oil. Once
the reservoir is full ensure the lid is placed over the reservoir. Ensure the
quick disconnect fitting with hose is fully seated to the fitting on the bottom
of the oil saddle.
The system is now ready for operation. As the fryer heats to preprogrammed
temperatures, the system will energize and then slowly add oil to the frypot
as needed, until the oil reaches an optimal level.
3.3.2 Routine Oil Changes
When the oil reservoir level is low, the controller displays
TOPOFF OIL EMPTY
in the left
display and
YES NO
in the right display. Press
(
YES
)
and follow the prompts.
Once the JIB is
replaced or the saddle filled press and hold the JIB button for 5 (five) seconds to reset top off system.
Some procedures may differ from photos shown. Follow manufacturer’s instructions for changing the
JIB. If using a saddle oil reservoir see section 3.3.2.2.
3.3.2.1 Routine Oil Changes
(JIB only)
1. Open the cabinet and slide the JIB
from the cabinet (see Figure 4).
Figure 4
2. Remove the cap and pour any remaining oil in the
container into all fry vats equally (see Figure 5).
Figure 5
3. With the jug upright remove the cap
and foil seal (see Figure 6).
Figure 6
4. Put the tube in the new full container (see Figure 7).
Figure 7
5. Slide the JIB onto the shelf inside the fryer cabinet (as
seen in Figure 4).
6.
Press and hold the orange JIB reset switch
five (5)
seconds
to reset the top off system
(see Figure 8).
Figure 8
WARNING:
Do not add HOT or
USED oil to a JIB or
Saddle Oil Reservoir.
Figure 3