M&R 12 COLOR, Руководство пользователя

Страница: 32 / 241

M&R Printing Equipment, Inc. - Glen Ellyn, Illinois
24
WARNING! Do not operate the
Omni/Uni Flash cure unit if the flip-up
front screen holder assembly does not
lock securely into position. Serious
injury to personnel or damage to the
equipment can result if the front screen
frame holder does not lock securely in
the raised position.
3. Roll the M&R Omni/Uni Flash cure unit into position, in
line with the selected print station. (See Fig. 3)
4. Using the round height adjustment handle located at the
top rear of the M&R Omni/Uni Flash unit. Adjust the height
of the infrared heating panel enclosure so that it is slightly
above the front end plate. (Latch clamp assembly locking
bracket. (See Fig. 4 & 4A)
Be sure to loosen the ratchet knob, (Kipp Elisa Knob) that
secures the two telescope tubes together, before making
this adjustment. (See Fig. 5)
5. Check to be sure the front mounting bar is straight (no
angle) by loosening the two ratchet knobs (Kipp Elisa
Knobs) and turning the mounting bar. (See Fig. 6)
6. Next, adjust the squeegee/flood bar pressure adjustment
knobs (turn clockwise) until the squeegee/flood bar is fully
raised. In this position the squeegee/flood bar will not per-
form the “chopper” motion in the event the print station is
inadvertently turned on. In this way damage to the radiant
panel is eliminated. (See Fig. 7 top left next page)
Omni/Uni Flash Operation
WARNING!
Fig. 2
Fig. 3
Fig. 4
Fig. 4A
Fig. 5
Fig. 6