M&R 12 COLOR, Руководство пользователя

Страница: 139 / 241

Kebco Frequency Drive Error List
M&R Printing Equipment, Inc. - Glen Ellyn, Illinois
131
Display Plaintext Combivis
Value Meaning
E.SET
ERROR set 39 Error: Set selection: It has been attempted to select a locked
parameter set.
E.PRF
ERROR prot. rot. for. 46 Error: Locked direction of rotation clockwise.
E.PRR
ERROR prot. rot. rev. 47 Error: Locked direction of rotation counter-clockwise
E. PUCI E. power unit code invalid
49 Error: during the initialization the power circuit could not be rec-
ognized or was identified as invalid.
E.PUCH ERROR power unit
changed
50 Error: Power circuit identification was changed; with a valid
power circuit this error can be reset by writing to SY.3. If the
value displayed in SY.2 is written, only the power-circuit depen-
dent parameters are reinitialized. If any other value is written,
then the default set is loaded.
E.DRI
ERROR driver relay 51 Error: Driver relay. Relay for driver voltage on power circuit has
not picked up although control release was given.
E.HYB
ERROR hybrid 52 Error: Invalid encoder interface identifier
E.iED
ERROR input error detec-
tion
53 Error: Hardware error during the start/stop measurement.
E.CO1
ERROR counter overrun 1 54 Error: Counter overflow encoder channel 1
E.BR
ERROR brake 56
Error: This error can occur in the case of switched on brake con-
trol, if the load is below the minimum load level at start up or the
absence of an engine phase was detected.
E.INI
ERROR initialization MFC 57 Error: MFC not booted
E.OS
ERROR over speed 58 Error: Real speed is larger than the max. Output speed.
E.CO2
ERROR counter overrun 2 55 Error: Counter overflow encoder channel 2
FAcc
forward acceleration 64 Forward acceleration
FdEc
forward deceleration 65 Forward deceleration
Fcon
forward constant 66 Forward constant run
rAcc
reverse acceleration 67 Reverse acceleration
rdEc
reverse deceleration 68 Reverse deceleration
rcon
reverse constant 69 Reverse constant run
LS
low speed 70 No direction of rotation preset
SLL
stall 71 Constant current limit active
LAS
LA stop 72 Acceleration stop active
LdS
Ld stop 73 Deceleration stop active
SSF
speed search 74 Speed search function active
dcb
DC brake 75 DC-brake active
bbL
base block 76 Power modules for motor de-excitation locked
dLS
low speed/DC brake 77 No direction of rotation preset after DC-brake
POFF
power off 78 Power-Off-function active
StOP
quick stop 79 Quick stop active
E.ccd
ERROR calculation drive 60 Error: During the automatic motor stator resistance measure-
ment.
E.HYBc ERROR hybrid changed
59 Error: Encoder interface identifier has changed, it must be con-
firmed over ec.0 or ec.10.