2 - Blending
3 - Meat mincer
Before you start, make sure that you assemble according to Fig. 3.
2.1 - Assembly the accessory
•
Place the unit head in the horizontal position and make sure
the appliance is switched off or unplugged.
•
Remove the rear output cover (5) by press and move it along
the arrow direction.
•
Place the blender Jar on the rear outlet by rotating it
clockwise.
2.2 - Usage
•
Start by turning the rotary button (8) to the desired position
according to the recipe.
•
Use the “P” position for better mixing control or for ice
crushing until the ice is finely crushed.
•
You can add food through the hole in the measuring cup
during preparation.
•
To stop the appliance, turn the button (8) to “0”.
Note:
•
Never fill the blender jug with boiling liquid. Only use liquid
or foods at simmering temperature or below.
•
Never run the blender jug empty.
•
Never use the blender jug without its lid.
•
Never remove the lid before the blades have stopped
completely.
•
Always pour liquids or add ice cubes to the jug when use the
blender.
2.3 - Dismantling the accessory
•
Wait for the appliance to come to a complete stop before
remove the blender.
•
Unlock it in the anti-clockwise direction and put the rear
cover (5) on the position.
2.4 - Recommend function recipe
•
Recipe: add water and carrot (cut size 15mm*15mm*15mm)
in proportion of 3 to 2 (by volume).
•
Method: operate unit for 2 minutes at highest setting.
•
Result: it is acceptable that carrots shall be blended into
pieces within specific time and juices shall not contain more
than 4mm cubes.
Before you start, make sure that you assemble according to Fig. 4.
3.1 - Assembly the mincer accessory
•
Hold the mincer body (9) by the feed tube, with the wider
opening uppermost.
•
Insert the feed screw (5) (gear side first) into the body (9).
•
Fit the cutter blade (4) onto the shaft side from the feed
screw (5) with the cutting edges facing outwards.
•
Fit the grinding disk A or B (6 or 7) on the blade (4), aligning
the hole of disk with pin in the body (9).
•
Screw the nut ring (8) on the body in the clockwise direction
and lock it by the spanner (12).
3.2 - Fitting the mincer accessory on the appliance
•
Facing the front outlet, insert the assembled mincer head
inclined to the right, aligning the two bayonets in the mincer
head with the two notches in the outlet.
•
Push the mincer head into the outlet and turn the mincer
head anti-clockwise until it latches with the feed tube in the
vertical position.
•
Place the removable tray (2) on the feed tube.
GB-16
GB-17
