55
The dampers are transported in covered transport, there must be no severe shocks and the
ambient temperature must not 50°C. When handling during transport, the dampers must
be protected against mechanical damage and weathering. The damper blade must be in a
"CLOSED" position during transport.
Depending on the weight of the delivery, it's advisable to provide handling equipment for stacking
at the unloading location.
If the acceptance method isn't specified in the order, handing over dampers will be considered
acceptance.
Dampers must be stored in covered buildings, in an environment free of aggressive vapours,
gases and dust. A temperature in the range of -5°C to +40°C and relative humidity max. 80% must
be observed in the buildings. When handling during storage, the dampers must be protected
against mechanical damage.
The scope of delivery includes a complete damper and delivery note.
Dampers are delivered on special pallets. As standard, the dampers are wrapped in plastic foil
for protection during transport and must not be used for long-term storage of the equipment .
Changes in temperature during transport may cause condensation of water vapour inside the
packaging and thereby condisitions may arise inside the packaging that are suitable for corrosion
of materials used in the equipment (e.g. white corrosion on zinc-coated items or mould on calcium
silicate). Therefore, it is necessary to remove the transport packaging immediately after unloading
to allow air to circulate around the product.
The equipment must be stored in clean, dry, well ventilated and dust-free environment out of
direct sunlight. ensuring protection against moisture and extremes of temperatures (minumum
tempe5°C) the equipment must be protected against mechanical and accidental damage
prior to installation.
Another required packaging system should be approved and agreed by manufacturer. Packaging
material is not returnable in case that another packaging system (material) is required and used
and it is not included into final price of damper.
Содержание SEDM-L
