22
1 Hinge "I/15"
3 Washer 6.4
5 Insulated reflector "I/15" 7 Holder of the
insulated reflector
2 Bolt M6x12
4 Nut M6
6 Frond washer 6.4
7
2
3
6
4
5
1
As for the wall design of "U/15, I/15", attach additional hinge to the consoles on the side of the peak
by using straps and nuts (Fig. 29, 30 a 33).
As for the design of "I", place an protection pipe to the hinges (protection of connecting cable
between burner box and exhaust box).
As for the wall design, the protection pipe must be located on "rear side" (lower side of the radiant
heater) (Fig. 33, 35).
6. Fit all hanging points with chains or strings, hanging rods, etc.
Lift the infra-red heater to the proper height level and ensure that it is hung in horizontal position.
Always make sure that the fasteners have sufficient load capacity.
Placing of the gas spinners.
Gas spinners in heaters Helios-I are placed in the last heating tube in front of the exhaust box.
Gas spinners in heaters Helios-U are placed immediately behind the arc in the direction of the flue
gas stream. Insert the spinners into the pipe before joining the pipes with the arc.
Place the burner and exhaust box on the hanging body (Fig. 38, 39).
Heater type
10-U+
20-I+
20-U+
20-LU+
50-LU+
–
No. of spinners
1
2
1
2
3
–
Heater type
30-I+
30-U+
30-LU+
40-I+
40-U+
40-LU+
No. of spinners
2
1
2
2
2
2
Exhaust box
Spinner
Black radiant tube 102x2
Содержание HELIOS
Страница 1: ......
