Ref.: WB-VL-SM Ver.1 3.doc
8
2.5.3.
WIDTH MEASURING ROD
(Applicable only for Premium model)
1.
Remove the Bracket back sheet from Bracket.
2.
Fix the Width rod assy with bracket using Allen screw & Spring washer
(2 Nos.) each. Ensure the Width assy is perpendicular to cabinet.
Fig. 7
3.
Route the Width assembly cable through the bracket and connect with
the Width cable from DSP board by ensuring the orientation.
4.
Fix the Bracket back sheet with Bracket using WH-PH screw (2 Nos.)
without damaging the routine cables.
2.5.4. MCD
1.
Insert the Threaded shaft into Tyre seating cone and fix the assembly
with Rotor Main shaft firmly using Allen screw & Spring washer (1 No.)
each by matching the Arrow stickers pasted in both the Tyre seating
cone & Main shaft.
2.
In case of HCV model, fix the Threaded shaft with Rotor assembly firmly
using correct size Spanner.
3.
Ensure the Rotor shaft is free from Runout. Else correct it.
TYRE SEATING
CONE WITH STUD
ALLEN KEY
(10mm)
WHEEL CLAMPING
SHAFT - THEAD SIDE
ALLEN
SCREW
Fig. 8
4.
Fix the Cone holding stems with left side of cabinet.
5.
Locate the Wheel seating cones with the respective Stem in case of LCV
models
6.
Finally verify & ensure the cabinet is free from tilt again.
Содержание LX WB-VL-65 DSP
