MANATEC LX WB-VL-65 DSP, Руководство по эксплуатации

Страница: 5 / 48

Ref.: WB-VL-65 DSP LX Premium - OM Ver.1.6 (B2927)
2
MAXIMUM WHEEL WEIGHT : 65 kg
MAXIMUM WHEEL DIAMETER : 39" (990 mm)
MAXIMUM WHEEL WIDTH : 21" (533 mm)
ATTENTION
2. SAFETY
Thoroughly read all Safety labels and Manual instructions before installing, operating and
maintaining the Wheel balancer. They are provided to prevent personal injury and property
damage. Replace any label unreadable or missing on the Wheel balancer. Refer Part No. given
for each labels for ordering. Always keep the Manual in a prominent place for quick reference.
Injury to personnel and damage to property incurred due to non-compliance with these safety
instructions are not covered by the product liability regulations.
SYMBOLS
Failure to comply with instructions could result in personal injury
Failure to comply with instructions could result in property damage
Important information
2.1. INTENDED USE

Always observe the rated load capacity of
the Wheel balancer.

Use the Balancer as described in this
Operating manual only.

Wheel guard must be kept closed during
spinning of wheel in the Balancer.

Use only the accessories recommended by the manufacturer.

Always use appropriate accessories for mounting various types of wheels.
2.2. SAFETY INSTRUCTIONS FOR COMMISSIONING
1. Only authorized service personnel are allowed to install and commission the
Wheel balancer.
2. DO NOT HOLD the shaft or its base for lifting / moving the Balancer. Even the
slightest bend of the shaft will affect the accuracy of the equipment. Use Lifting
handles for lifting the Balancer.
3. The Balancer should not be installed outdoors or in moist rooms.
4. To reduce the risk of fire, the equipment should not be installed at hazardous
locations or in the vicinity of explosives or flammable liquids.
5. The floor should be properly leveled beneath the Balancer and should be free of
heavy equipment vibration.
6. The Balancer must be anchored to the floor, since large unbalance in wheels can
cause heavy vibration which leads to repeated runs for balancing.
7. The electrical main supply to the Balancer must be connected through a CE
certified MCB with ratings as given below:
For 230V 50/60Hz operation: Two pole, Type C, 6A MCB
For 110V 60/50Hz operation: Two pole, Type C, 10A MCB
8. Proper Earthing must be provided.
9. If an Extension power cord is required, a cord with correct rating equal to or more
than that of the equipment should be used.
10. Care should be taken to route the Power mains cord properly so that it is not
tipped over or pulled.