MANATEC LX WB-VL-65 DSP, Руководство по эксплуатации

Страница: 29 / 48

Ref.: WB-VL-65 DSP LX Premium - OM Ver.1.6 (B2927)
26
7.4.2. WHEEL RUN
Fig. 23
In case of Alloy wheels, Split weights program can be used to split
the balancing weight on Outer plane alone to hide the weights behind
the Spokes (Refer Chapter 7.5.1)
In Balancing mode & Split weight function for Alloy wheel rims, in
which sticker weight to be used (Inner and Inner most), the weight
adding position will be indicated in 12
o‟ clock position when the
Sticker weight Holder mode selected and 6 o‟ clock position when
Laser mode is selected. For Sticker weight Holder mode, the weight
should be added only by the holder at the meeting point in the rim
surface. DO NOT ADD AT THE CENTRE OF RIM (TDC). For Laser
mode, Laser line will be indicated (for model only). Add the
sticker weight in this position
For all wheels, Inner plane weight adding position ( ±20°) the Torch
light will be ON, just for illumination (for model only).
At the weight adding position, Torch light will toggle On/Off to
enhance the visibility of the Laser line
If “
Weight Calibration data is not available. Redo weight calibration
(or) Restore Factory calibration
” message is displayed, press
key
to clear message. Calibration to be done before proceeding further
Check and ensure that the Distance measuring rod and Width measuring rod
are at Home position.
The respective settings can be set in POSITION TRACKING screen for
the current wheel balancing sequence alone using
/
keys and
pressing key . For permanent settings, use SETTINGS screen.
The settings made in the POSITION TRACKING screen will be
reflected in the status bar
Start balancing run by pressing the key twice or by lowering the Wheel
guard if Auto run mode is enabled in SETTINGS screen (Refer Chapter 8).
DYNAMIC BALANCING MODE STATIC BALANCING MODE
Fig. 24
Now the wheel will start spinning for few seconds, when measurement is
completed the Wheel mounting shaft will be stopped via E-Brake. The Inner
and Outer unbalance weights will be displayed on the respective windows.
The Unbalance position is indicated graphically by small red circles on the
wheel images for both Inner and Outer planes. Rotate the wheel manually to
bring the red circle to the Top most position for Inner plane.