To have Solder that flows
correctly, make sure that
the Soldering Iron is in
contact with the solder pad
and the component’s lead
at the same time. Then
apply your solder until it
flows through to the other
side. After completing your
soldering joint, trim the lead
at the base of the PCB.
solder pad
solder
lug
wire
soldering iron
circuit board / PCB
leads
To attach a wire to a lug of a
jack or pot, strip
approximately 1/4” of the
wire jacket. Wrap the
stripped wire around the
opening in the lug. Clamp
down on the wire so it is
tight on the lug, the apply
solder as you do a part on
the board. The lugs are
much larger than the part
leads and may take more
time to heat before the
solder will flow freely.
If you have any questions about building the J201 Clean Boost or need any help with trouble-shooting, please send us an
email at [email protected] or give us a call at 405-254-4112.
