3
4Site
SW1
1
2
4
5
6
7
LRG3PDT
Wire to Ground Lug of Battery Clip
Wire to Main Ground Lug of Output Jack
3PDT Wiring Board – Solder Pins to the Lugs of the 3PDT Provided,
Printed-Side of the Board Facing up.
Anode (positive side) of LED.
Connect to Hole 1 of D2 on Main PCB.
Cathode (negative side) of LED.
Connect to Hole 2 of D2 on Main PCB
Wiring from the 3PDT Wiring Board (See Diagram)
Pin 1- Input signal to the main board. Wire to connection point labeled “IN”.
Pin 2- Input signal from input jack. Wire to signal lug of input jack.
Pin 3- Main Ground. Wire to center ground lug on input jack
Pin 4- Output signal from main board. Wire to connection point labeled “OUT”.
Pin 5- LED ground (cathode) Wire to connection point labeled “LED –“.
Pin 6- Output signal to the output jack. Wire to signal lug of output jack.
Pin 7- Not used. Can be used as extra ground point if needed. Pins 3 and 7 are tied together.
If you have any questions about building the J201 Clean Boost or need any help with trouble-shooting, please send us an
email at [email protected] or give us a call at 405-254-4112.
Positvive Wire of Battery Clip
Wire to Main 9v +
Lug of DC Jack
Wire to DC Jack Ground Lug
500kA
