Wiring from the Click-Less PCB (See Diagram)
Pin + : Wire to Main 9V power lug of DC Jack
Pin - : Wire to Main ground lug of input jack
Pin C : Not Used
Pin S2: Wire to lug of N/O SPDT Click-Less switch
Pin S1: Wire to lug of N/O SPDT Click-Less switch
Pin L: Wire to anode (positive leg) of LED
Pin R: Wire to connection point labeled “OUT”
Pin O: Wire to signal lug of output jack
Pin I: Wire to signal lug of input jack
Pin S: Wire to connection point labeled “IN”
If you have any questions about building the J201 Clean Boost or need any help with trouble-shooting, please send us an
email at [email protected] or give us a call at 405-254-4112.
Wire to Ground Lug of Battery Clip
Wire to Main Ground Lug of Output Jack
Anode (positive side) of LED.
Connect to Pin L of Click-Less PCB.
Cathode (negative side) of LED.
Connect to Hole 2 of D2 on Main PCB
Positvive Wire of Battery Clip
Wire to Main 9v +
Lug of DC Jack
Wire to DC Jack Ground Lug
Wire to DC Jack Ground Lug
500kA
Click-Less Momentary
SPDT Foot Switch
