– 23 –
FITTING THE PRIMO VIAGGIO CAR SEAT
Push the car seat down onto
the attachment brackets until
it locks into place.
Check the car seat is firmly
attached by attempting to lift
it from the pushchair.
Note:
You may find the car
seat easier to fit if you open
one side of the bumper bar.
Always lock the bumper bar
once the seat is fitted.
Apply the brakes.
Recline the backrest to its
lowest setting (
see page 9
),
then raise it up one position.
Lock the bumper bar in the
outer position,
see page 7
.
In the corners of the seat
where the backrest joins the
seat base, there are two fabric
flaps. Under the flaps are the
two attachment brackets.
Rotate the attachment
brackets up until they lock in
the vertical position.
Make use of the harness tidy
(
see page 15
) to keep the
safety harness away from the
attachment brackets.
With the car seat facing
towards the rear of the
pushchair, align the two
centre recesses in the sides of
the car seat with the
attachment brackets. Then
lower the car seat onto them.
– 22 –
Push the bottom part of the
apron under the bumper bar
alongside the leg rest.
ATTACHING THE APRON
Fasten the zip on the bottom
edge of the apron to the zip
on the front edge of the
footrest cover.
Removal is the reverse of
fitting.
