MAM Easy Start Anti-Colic, Руководство пользователя

Страница: 16 / 36

16
4. Using the appliance
4.1. Electric pumping
4.1.1. Assembly
For hygienic reasons, please wash your hands thoroughly before assembling the breast pump.
• Place the silicone cushion into the funnel adapter. Make sure to connect the silicone cushion to the rim
of the funnel properly by fitting it over the rim (Fig. 1).
• Place the membrane into the funnel adapter, cover with the membrane cap and screw on tightly (Fig.
2).
• Carefully press the valve membrane into the hole of the valve body until it engages. The valve mem-
brane should be pressed flat and tight to avoid air leakage (Fig. 3).
•
Please note:
the valve membrane ensures that there is a total barrier between the breast milk and any
pathogenic agents.
• Now correctly place the valve membrane with the valve body onto the funnel adapter (Fig. 4).
• Firmly screw the bottle onto the funnel adapter (Fig. 5).
• The tubing has two connectors on the two ends. Attach the connector to the air vent of the membrane
cap (Fig. 6) and the one on the pump unit separately, ensuring a tight fit (Fig. 7).
Fig. 6 Fig. 7 Fig. 8
Fig. 1 Fig. 3 Fig. 2 Fig. 4 Fig. 5
4.1.2. Charging the electric pump unit and pumping in mains operation
• When the adapter is connected to the pump, the pump can be powered and the battery charged at the
same time.
• For charging or pumping when the battery is empty, connect the plug to the pump unit and insert the
adapter into an electrical socket (Fig. 8). To charge, switch the toggle switch at the bottom of the pump
to OFF.
• For pumping, make sure that the toggle switch is switched to ON. The LED on the pump will flash, indi-
cating that the device is in standby mode.
• When the battery power is low, the pump will switch off automatically.
• Once the battery is fully charged, it will stop charging to protect the battery from damage.
4.1.3. Preparing for pumping
• Wash your hands with soap and your breasts and nipples using a warm washcloth and clean fresh
water.
• Squeeze a little bit of milk out of each nipple to make sure the milk ducts are not clogged.
• Ensure that all parts of the pump are clean and disinfected before use.
• Before using, make sure that the pump is properly assembled and fully screwed onto the bottle.
• Ensure that the toggle switch at the bottom of the pump unit is switched to ON and that the battery is
charged or the pump plugged into an electrical socket.
• Place the funnel firmly on your breast. Make sure that no air escapes through the side, otherwise no
suction will develop.