Malmet Blanket Warming Cabinet
Operation, Maintenance and Installation Manual
Issue 20
Page
5
Jun-23
1.1 Device Operation
NOTE
The Blanket Warming Cabinet is factory set to 60°C
Before starting the device
The device should be run initially on a power supply not protected by an earth leakage circuit breaker for
approximately three hours. This will allow any moisture in the heaters to dry out. The device can then be
connected to an earth leakage circuit breaker protected circuit if required.
Plug into standard 240V outlet.
Starting the device
Press the Standby Button, the pre-set temperature of the cabinet appears for approximately five seconds. After
five seconds the device switches to display the actual cabinet temperature.
1.2 Control Display Features
1.3 Operating Features
ON/Off Standby Button
UP and DOWN Temperature Buttons
DISPLAY