MAKSIWA SC.1100.X, Инструкция по эксплуатации

Страница: 24 / 52

24
4 Unpacking and Checking Contents
ATTACH SWITCH ASSEMBLY
Refer to following fi gure.
• Remove the thread forming screw and the battery cover. Insert the two AAA batteries and replace the battery
cover and thread forming screw.
The laser is an optional accessory. If your machine has not this part, skip this step.
• Place the slot of blade guard body over the riving knife. Slot of bushing is placed in the notch indicated in
following fi gure.
• The bushings have a beveled edge and must be located in the center of the notch to lock properly.
• Position guard completely down on riving knife and press latch to lock in position.
• Blade guard body should be parallel to the table. If not, adjust the 2 set screws as necessary.
• Place anti-kickback pawl set onto riving knife at notches indicated. The spring pin is placed in the front notch
and bolt is placed in the rear notch.
• Press pawl set completely down and press latch to secure in position.
NOTE: The teeth of anti-kickback pawls should touch table surface. Use set screws to adjust if needed.