MAKSIWA SC.1100.X, Инструкция по эксплуатации

Страница: 37 / 52

37
6 Maintenance
replaced immediately.
• Make sure teeth of anti-kickback pawls are always sharp.
• Sharpen dull teeth using a few light strokes of a smooth cut fl at fi le.
6.5 Changing the Saw Blade
Refer to following fi gure.
WARNING: Turn the power switch “OFF” and unplug the power cord from its power source when changing the
saw blade.
WARNING: When replacing blades, check the thickness stamped onto the riving knife. You must select a blade
with a kerf width larger than the thickness of the riving knife. Thinner blades may cause the workpiece to bind
during cutting.
WARNING: USE ONLY 10″diameter blades with 5⁄8″arbor holes, rated at or higher than 3800 R.P.M.
• Remove blade guard assembly and pawl assembly.
• Remove the table insert.
• Unlock the raise/lower handwheel lock and raise saw blade to maximum height.
• Pull out the arbor lock and hold arbor in locked position.
• Place supplied 24mm wrench on the arbor nut. Turn wrench counterclockwise to loosen nut. Remove arbor
nut, blade fl ange and saw blade.
• Place new blade on arbor. Make sure saw blade teeth point down at the front side of saw table. Place fl ange
and nut on arbor and securely snug blade in position.
• Replace table insert.
• Replace blade guard assembly and pawl assembly.