5
3. Assembly of Extension Table
Enter the two Adjustable Guides (2) into the holes of the
main structure leaving 2inches ends out and screw the
knobs (3) by pressing them on the guides:
Remove the screws of the guides and insert the
extension table on the guides and fix it with screws using
the key 10 (8) for final tightening:
4. Swinging Support Installation
Remove the screw from the shaft of Swinging Support
(4), positioning at its point of attachment to the structure
and screwing tightening using the key 13 (8), as the
following figures:
One of the supports of the Piston (6) is already mounted
on the Swinging Support (4) and the other are the group
of nut and hexagon socket screw (Allen) M6 (5) to be
mounted on the upper end of the scraper set, as shown
in the figure below, tightening the nut with the key 10 (8):
Remove the locks of the ends of the Piston (6), fitting in
their respective supports and replace the locks, as the
following figure:
