9
OPERATIONS
The operations made by the Edge Trimmer RBB.1000,
as well as any other machine, can pose risks to the
operator if the instructions in this section are not taken
into account.
ATTENTION: BEFORE TURN ON NOTE IF
YOUR POWER SUPPLY IS COMPATIBLE
WITH THE VOLTAGE OF THE EQUIPMENT.
These instructions are written with the understanding
that the operator has the knowledge and skills
necessary to operate this machine. If at any time you
feel difficulty performing any operation, stop using the
machine. If you are an inexperienced operator, we
recommend that you read books, technical papers, or
seeks training from an experienced operator before
performing any operation unknown. The machine must
operate with all the protections and security systems that
comes standard.
Above all, your safety must come first.
To get a good result at the finishing with RBB.1000 is
important that the preparation of the workpiece and the
collage of the edge tape have been carried out correctly.
You can only work with straight cuts and straight angles
(90°).
It is recommended the application of equipment for use
only in pieces with edge tapes with a maximum
thicknesses up to 1.0 mm.
1. EXTENSION TABLE
The extension table should be adjusted according to the
width of the piece to be worked, and any position
exceeding the median part of the piece width is already
satisfactory.
2. PROTEÇÃO E EXAUSTÃO
In the operation area is a compartment enclosed by a
transparent polycarbonate cover, which serves as a
safety device, also forming an exhaust system. To
activate the exhaust, just snap on your connection
located above this compartment, a hose of an exhaust
system or even a professional or residential vacuum
cleaner.
The transparent cover must be adjusted approximately 5
to 10 mm above the surface of the workpiece.
3. SCRAPER
The scraper must be adjusted to the thickness of the
piece to be worked.
Loosen the knob of the scraper block and lift it then
introducing one piece or retail model to be worked. This
should be without the edge tape, or if it is already with
the tape that should already be pre-shaper, at least a
little stretch.
Down again the scraper, resting it on the surface of the
piece. With the left thumb exerting a light pressure on it,
fixing it again the knob.
Then, once completed this step, the piece used for the
adjustment should be removed.
4. OPERATION
Separate the pieces to be worked, properly prepared,
noting that the remains of tapes at the ends of the tops
are of no more than 7 to 8 mm
(5/16’’) and also no folds:
