10
Turn on the trimmer/router through the ON/OFF switch,
and when use the exhaustion system, also turn it on:
Insert on the table the piece to be worked and moves it
toward the cutter and scraper, noting that the edge to be
worked always keep in touch against the side guide
(guard- rail). Perform this action with a rectilinear and
uniform motion until the entire length of the edge pass
by the scraper device:
Then turn the piece and repeat the action in the opposite
edge of the same tape. Repeat these actions on all
edges to be worked.
At the end of the process should be cleaned the piece,
removing the waste of tape from the trimming and also
the remaining of glue excesses using a cloth with
kerosene or other solvent.
MAINTENANCE
IMPORTANT:
All maintenance or cleaning on
the machine must be made with the same
OFF
and
unplugged
from the outlet to prevent accidental
discharges.
Periodic maintenance on your Edge Trimmer RBB.1000
MAKSIWA will ensure optimum performance. Make it a
habit to inspect your equipment every time you use it.
This section covers the service adjustments or common
procedures that may need to be made during the life of
your machine.
Verify if the following conditions for repair or
replacement are needed:
• Loosen screws.
• Switches or buttons damaged.
• Cables, plugs or sockets worn or damaged.
• Cutter and scraper bit damaged.
• Any other condition that could adversely affect the safe
operation of the equipment.
CLEANING
The tape residue contaminating the bearings of the
cutter and the scraper device (copiers), causing braking,
which may cause marks on the surface of the piece. Is
needed to clean and lubricated periodically, using
lubricant spray.
