Strona
17
z
26
4.2.8. Pausing the program.
The controller allows to pause (hold) the program execution during its duration. This
function allows you to interrupt the program at any time and resume it, which happens
exactly in the same place, in which the program was paused.
4.2.9. Disabling the program.
The controller is equipped with a button that disables the program at any time, without
the possibility of resuming it at the switch-off point. Restarting the program will cause
launching the program from the very beginning.
4.2.10. Displaying the time remaining.
During the program execution, the controller displays the time remaining until the end
of the program.
ATTENTION
The time indicated on the display does not take into account the time of pouring
water.
4.2.11. The function of dependence on the completion of pouring water from the
hydrostatic signal.
The controller allows to program the end of the water dispensing proces from obtaining
a signal from a hydrostatic. This function is secured by setting the maximum time for
pouring water in the event of mechanical suspension of the hydrostatic.
4.2.12. Water heating control (only MCH-07T v. 2 version).
The MCH-07T v. 2 version has a built-in temperature regulator that allows you to control
the heating of water. This function requires the connection of a temperature sensor and
the setting of the temperature of the water heating – the factory setting is 45
O
C).
4.3. Washing segment use by the installer.
The controller is factory-programmed for standard operating conditions for the purpose
of washing: milk cooler (2 programs) and milking devices (2 programs). Nevertheless,
to ensure proper operation of the controller under specific conditions, appropriate
adjustments of the operating parameters can be made, including the selection of the
appropriate program. Deafault washing programs can be edited according to the user's
needs or you can create your own program.
After the controller has been installed, the correct operation of the entire washing
system can also be checked in an accelerated mode using the test mode.
